Macos monterey update stuck at about a minute remaining install#
Possibly when the install process shifts from the USB to the hard drive. Sometimes it hangs later in the install because that particular USB port stops working. Turning off 'Above 4G decoding' BIOS option resolved the problem with NVRAM. Fallback to OsxAptioFixDrv2 + EmuVariableUEFIDrv solved my problem. It turned out that "hardware" NVRAM doesn't work with AptioMemoryFix on this motherboard. Running the second stage in Safe Mode panics with "process 1 exec of /sbin/launchd failed". Seems to be a normal behaviour. However, the second stage ("install macOS from ") still hangs. Moving a bit further. The first stage of installation goes fine in Safe Mode (-x). Installation log indicates the same log message and after that it reboots immediately. Please help me to figure out what's wrong. Lastest dev beta (common) did not fix it - hangs. Hangs.Ĭhanging to iMac18,3 did not help as well. Tried to install using another SSD drive. I rule that out by installing from recovery partition with all USB drives disconnected. USB drive failure or disconnected USB port. Special build for iMacPro or ordinary build - installing both builds hangįlash drive prepared using 'createinstallmedia', BDU or using RecoveryHD - all hang Locked or unlocked MSR 0圎2 - both cases hang But I cannot install the updates because of the same hanging at the end! Next, if I try to boot what was finally installed I can even get to working system. Unfortunately, it stucks at the end again. If I then reset the system and boot what was installed I can continue the installation. The last messages I can see in the installation log are at the picture attached to this post. The installation process hangs when 'less than a minute left' is displayed on screen. I'm trying to install 10.13.3 for iMacPro on SATA SSD.
0 kommentar(er)
